Sliding Rooflights > GV Standard Sliding Over Fixed Rooflights

Gallery (Click to enlarge)


Introduction
One of a Standard range of our sliding glass rooflights. A range of Standard Rooflights has been designed to offer the customer a more cost effective alternative to our bespoke sliding rooflight range.

The GV Standard Sliding over Fixed rooflight comes in 2 sections, one sliding section sliding over one fixed section, creating a 50% clear opening. All the glass used is flush to allow water run off and easy cleaning.

All Glazing Vision sliding rooflights are low-noise in operation and have built in electronic solid-state controls with battery back-up, manual override, speed control and creep-speed sealing at end of travel as standard. Units are factory pre-assembled and tested, usually craned into position, fitted and commissioned within day, Glazing Vision installation recommended.

The rooflight is opened electrically, operated by a rocker switch positioned at the discretion of the client. It includes a ‘one touch’ facility, where the switch is pressed then released leaving the rooflight to open automatically. If you wish the unit to stop, press close once. If you wish to have the unit only part open, you can keep the switch pressed until this point is reached.

Colour- all our Sliding rooflights are Powder coated to RAL7015 Grey an alternative of RAL9010 White Inner is available as standard, alternative paint specifications are available however these can affect both price and lead times.

GV Standard Sliding Over Fixed Rooflight Technical Data
Sizes to the outside kerb dimensions
Pitch Angle Range: Recommend 5 degree pitch on kerb perpendicular to direction of travel, max pitch 10 degree
Clear opening: 50%
Maximum Span: 2400mm
Minimum Length (travelling): 1500mm
Maximum footprint area: 10m2
Speed of operation: 2-3m/min (variable) Framework: Aluminium
Finish: Polyester PowderCoated
Frame Colour: White RAL9010 matt and Grey RAL7015 matt
Glazing: Double glazed, safety glass
Std glass U-Value: 1.1 Centre Pane U-Value
Drive Voltage: 12 Volt DC
Supply Voltage: 220/240 volt AC

Anything larger than above can be catered for but would fall under our GV Bespoke Sliding Over Fixed Rooflights 28mm DGU Comprising of: 6mm clear toughened outer, 16mm Argon gas filled, black, silicone sealed spacer, 6mm clear lowE toughened inner.

All sliding rooflights are battery powered and trickle charged for continuous usage in the event of a power failure. All sliding rooflights are also fitted with a manual override.

Installation
Installation onto prepared roof apertures and up-stands is simple, each rooflight is supplied assembled, packaged with instructions and fitting kit. Either follow our detailed assembly instructions, or opt for an installation.

An on site lifting facility will be required to locate the heavier units to the roof location

Please remember when requesting a quote specify the outside dimensions of the upstand/kerb, you should then make an allowance of approximately 200mm for inside dimensions subject to chosen internal finishes dimension.

Ritec Coating-Those clients looking for easy clean glass can use a ritec coating on the glass to achieve a non stick surface and reduce cleaning intervals please ask for details on quotation. Ritec ClearShield protected glass:- Is always easier to clean and keep clean, Stays cleaner for longer, Resists staining and discoloration.
Blinds- Glazing Vision works in partnership with Thomas Sanderson the UK’s leading blind supplier to offer their range of blinds with our Flushglaze Rooflights, please ask on quotation for this price to be provided.
Warranty– All Sliding Rooflights come with a standard 5 year warranty (subject to Glazing Vision maintenance agreement)

Resources
Resource Centre [For registered users only]
Request a Quote
National Building Specifications (NBS)